Field notes // Water

How to make water safe to drink when the power is out

· 3 min read

Boil-water notice and no power? How to make tap or stored water safe by boiling or with household bleach, using the CDC and EPA guidance.

When the power goes out for a long time, water systems can lose pressure, and local officials may issue a boil-water notice. If they do, follow it exactly: they know what’s in your water. This note covers what the EPA and the CDC say to do when you need to make water safe yourself.

Start with the safest water you have

The CDC’s guidance is to use bottled, boiled or treated water for drinking, cooking and hygiene, and to boil your water if you don’t have safe bottled water. Ready.gov recommends storing at least one gallon of water per person per day, for several days, for drinking and sanitation. Count pets in that too.

If you don’t have enough stored water, you can treat tap water or water from another source. Boiling or disinfecting kills most germs. According to the CDC, it can’t make water with fuel or toxic chemicals in it safe: if you think your water has something like that in it, use bottled water or find another source.

If the water is cloudy, clear it first

Let cloudy water settle, then filter it through a clean cloth, paper towel or coffee filter. Pour the clear water into a clean container and treat that.

Option 1: Boil it

Boiling is the surest way to kill germs. The CDC’s guidance:

  1. Bring clear water to a rolling boil for 1 minute.
  2. At elevations above 6,500 feet, boil for 3 minutes. (The EPA’s page puts this cutoff lower, at 5,000 feet; if you live in between, boil for 3 minutes.)
  3. Let it cool on its own, then store it in clean containers with covers.

Boiled water can taste flat. Pouring it back and forth between two clean containers a few times puts some air back in.

Boiling needs a heat source. If you use a camp stove or grill, use it outdoors, never inside the house or garage.

Option 2: Household bleach

If you can’t boil water, the EPA explains how to disinfect it with plain household bleach. Use regular unscented chlorine bleach, not scented, color-safe or bleach with added cleaners, and check the label for the percentage of sodium hypochlorite (usually 6% or 8.25%). If the label has instructions for disinfecting drinking water, follow those.

Bleach strength Per 1 gallon of clear water Per 1 quart or liter
6% 8 drops (about 1/8 teaspoon) 2 drops
8.25% 6 drops (about 1/8 teaspoon) 2 drops

Double the amount if the water is cloudy, colored or very cold (EPA). Then:

  1. Stir the water and let it stand for 30 minutes.
  2. It should have a slight chlorine smell. If it doesn’t, repeat the dose and wait another 15 minutes.
  3. Store it in clean, covered containers.

Use a clean eyedropper for the drops, and keep it with your bleach so it’s there when you need it. Bleach loses strength over time, so check the date on the bottle you’re storing.

What to keep on hand

  • Stored water, rotated on a schedule you’ll remember.
  • A bottle of unscented bleach, a clean eyedropper and a printout of the table above.
  • Clean containers with covers.
  • A way to boil water outdoors.

Where Blackout fits

Blackout keeps prep lists for boil-water notices, field manuals and Wikipedia on one solar-charged device, searchable with no signal. If the printout gets wet or lost, the steps are still in your pocket. The AI models help you find and follow the references on the device; check what matters against the source.

Sources

More field notes